PRESSHEAR # 10

PUNCH CAPACITY - 18 TONS

ACCESSORIES SOLD SEPARATELY

PIPE NOTCHER - SPEAR POINT

BENDING DIE -  COPER

SQUARE TUBING CUTTER

NOTCHER - PUNCH OILING SYSTEM

DIMENSIONS

Overall Height: 66''
Floor to Shear Blade: 39''
20'' Wide x 34" Long

CAPACITY

2" x 2" x 1/4" Angles

3/4" Rounds

3/4" Squares

1/4" x 4" Flats

2" x 1/2" x 1/8" Channel

Cap Rails

Punch 7/8" Round Hole through 1/4" Material

Stroke: 2"

Shut Height: 6-1/2"

ps10.jpg (19706 bytes)

This machine is both a punch and a shear.

Cast-frame - high tensile ductile iron.

Operates on 1 HP, 1750 RPM motor.  Three phase or single phase available.

Foot operated, one stroke safety clutch.

Front is conventional press and can be used for punching or forming

Regular die sets will fit this machine

Adjustable ram.

Hold-down easily adjusted.

Punch can be lowered to material for center punching and will remain until clutch is engaged.

Blades are tool steel - Can be re-sharpened and adjusted.

Punch to back of throat - 3"

Bar hole for lowering punch by hand.

Blade guard, foot lever guard, and gear guard for operators protection.

Approximately 48 strokes per minute.